SI3DP test kit S8 — free · version 0.1
screwit3d.com · © Karel Šorejs

================================  ENGLISH  ================================

Find the right clearance for your printer before you print SI3DP screws and nuts.

  STL/SI3DP_S8_test_plate.stl   6 threaded holes, clearance +0.05 … +0.30 mm printed under each
                                hole (+0.15 = SI3DP standard, the cut corner marks the tightest)
  STL/SI3DP_S8x30_hex.stl       S8 × 30 screw, hex head — both ready to print
  FBX/  OBJ/  GLB/              the same two parts for 3D software, so you can check that they open
                                in yours: FBX → 3ds Max, Maya, Cinema 4D, Unity, Unreal · OBJ → almost
                                every program, Rhino · GLB → Blender, Unreal, web. Millimetres, head up.

  1. Print both as they are: the screw standing on its head, the plate flat. No supports,
     at least 4 perimeters, layer at most 0.2 mm. PETG, ASA or PA for real joints.
  2. Screw it into the holes and pick the one where it turns by hand without wobbling.
  3. Print nuts with that clearance. The full SI3DP screw set has 346 screws (S6–S20,
     three head types), nuts in all 6 clearances, washers and a test plate for every size,
     plus FBX, OBJ and GLB for 3D software: https://screwit3d.com/models/

Free for personal use (LICENSE.txt). Please share the link, not the files.

================================  ČESKY  ==================================

Najdi správnou vůli pro svou tiskárnu, než začneš tisknout šrouby a matice SI3DP.

  STL/SI3DP_S8_test_plate.stl   6 děr se závitem, pod každou vytištěná vůle +0.05 … +0.30 mm
                                (+0.15 = norma SI3DP, zkosený roh = nejtěsnější)
  STL/SI3DP_S8x30_hex.stl       šroub S8 × 30, šestihranná hlava — obojí připravené k tisku
  FBX/  OBJ/  GLB/              stejné dva díly pro 3D programy, ať si ověříš, že se ti otevřou:
                                FBX → 3ds Max, Maya, Cinema 4D, Unity, Unreal · OBJ → skoro každý
                                program, Rhino · GLB → Blender, Unreal, web. Milimetry, hlava nahoře.

  1. Vytiskni obojí tak, jak to je: šroub stojí na hlavě, destička leží. Bez podpor,
     aspoň 4 obvodové stěny, vrstva nejvýš 0,2 mm. Na opravdové spoje PETG, ASA nebo PA.
  2. Zašroubuj šroub do děr a vyber tu, kde jde rukou a neviklá se.
  3. Matice tiskni s touhle vůlí. Celá sada šroubů SI3DP má 346 šroubů (S6–S20, tři druhy
     hlav), matice ve všech 6 vůlích, podložky a destičku ke každé velikosti a k tomu FBX,
     OBJ a GLB pro 3D programy: https://screwit3d.com/models/

Licence: LICENSE.txt (anglicky).
